KMITL

Permanent URI for this communityhttps://dspace.kmitl.ac.th/handle/123456789/1

Browse

Settings

Author: search.filters.author.Kennedy, Francis E.Subject: search.filters.subject.EHL

Search Results

Now showing 1 - 2 of 2
  • Loading...
    Thumbnail Image
    Some of the metrics are blocked by your 
    consent settings
    Item type:Publication,
    Transient elastohydrodynamic lubrication in artificial knee joint with non-Newtonian fluids
    (2010-05-01)
    Mongkolwongrojn, Mongkol
    ;
    Wongseedakaew, Khanittha
    ;
    Kennedy, Francis E.
    This paper presents the transient analysis of a human artificial knee joint under elastohydrodynamic lubrication (EHL) for point contact with non-Newtonian lubricants. The artificial knee joints use ultra high molecular weight polyethylene (UHMWPE) against metal with time-varying speed and load during walking. This numerical simulation employed a perturbation method, Newton Raphson method and multigrid method with full approximation technique to solve simultaneously both the time-dependent Reynolds equation, with non-Newtonian fluid based on a Carreau model, and the elasticity equation. The general numerical schemes are implemented to investigate the characteristics of elastohydrodynamic lubrication in human artificial knee joints; profiles of pressure and film thickness are determined, with varying material and lubricant properties, applied loads and speeds. The results show that the elastohydrodynamic fluid film thickness between the metallic component of the artificial knee joint and the soft polyethylene bearing becomes larger as the contact area increases and the fluid film pressure decreases. At the beginning of the first walking cycle, the film thickness is lower than in subsequent cycles because of the time required to develop the fluid film; after the first cycle, the fluid film is similar for every cycle and is dependent on transient applied load and speed during human movement. © 2009 Elsevier Ltd. All rights reserved.
  • Loading...
    Thumbnail Image
    Some of the metrics are blocked by your 
    consent settings
    Item type:Publication,
    Elastohydrodynamic lubrication of rough surfaces under oscillatory line contact with non-newtonian lubricant
    (2008-09-01)
    Mongkolwongrojn, Mongkol
    ;
    Wongseedakaew, Khanittha
    ;
    Kennedy, Francis E.
    This paper presents the results of a transient analysis of elastohydrodynamic lubrication (EHL) of two parallel cylinders in line contact with a non-Newtonian lubricant under oscillatory motion. Effects of the transverse harmonic surface roughness are also investigated in the numerical simulation. The time-dependent Reynolds equation uses a power law model for viscosity. The simultaneous system of modified Reynolds equation and elasticity equation with initial conditions was solved using the multigrid, multilevel method with full approximation technique. The film thickness and the pressure profiles were determined for smooth and rough surfaces in the oscillatory EHL conjunctions, and the film thickness predictions were verified experimentally. For an increase in the applied load on the cylinders or a decrease in the lubricant viscosity, there is a reduction in the minimum film thickness, as expected. The predicted film thickness for smooth surfaces is slightly higher than the film thickness obtained experimentally, owing primarily to cavitation that occurred in the experiments. The lubricant film under oscillatory motion becomes very thin near the ends of the contact when the velocity goes to zero as the motion direction changes, but a squeeze film effect keeps the fluid film thickness from decreasing to zero. This is especially true for surfaces of low elastic modulus. Harmonic surface roughness and the viscosity and power law index of the non-Newtonian lubricant all have significant effects on the film thickness and pressure profile between the cylinders under oscillatory motion.