Loading...
Very low drift and high sensitivity of nanocrystal-TiO 2 sensing membrane on pH-ISFET fabricated by CMOS compatible process
Author(s)
Bunjongpru, W.
Sungthong, A.
Porntheeraphat, S.
Rayanasukha, Y.
Pankiew, A.
Jeamsaksiri, W.
Srisuwan, A.
Chaisriratanakul, W.
Chaowicharat, E.
Klunngien, N.
Hruanun, C.
Poyai, A.
Date Issued
February 15, 2013
Type
Article
Abstract
High sensitivity and very low drift rate pH sensors are successfully prepared by using nanocrystal-TiO 2 as sensing membrane of ion sensitive field effect transistor (ISFET) device fabricated via CMOS process. This paper describes the physical properties and sensing characteristics of the TiO 2 membrane prepared by annealing Ti and TiN thin films that deposited on SiO 2 /p-Si substrates through reactive DC magnetron sputtering system. The X-ray diffraction, scanning electron microscopy and Auger electron spectroscopy were used to investigate the structural and morphological features of deposited films after they had been subjected to annealing at various temperatures. The experimental results are interpreted in terms of the effects of amorphous-to-crystalline phase transition and subsequent oxidation of the annealed films. The electrolyte-insulator-semiconductor (EIS) device incorporating TiON membrane that had been obtained by annealing of TiN thin film at 850 °C exhibited a higher sensitivity (57 mV/pH), a higher linearity (1), a lower hysteresis voltage (1 mV in the pH cycle of 7 → 4 → 7 → 10 → 7), and a smaller drift rate (0.246 mV/h) than did those devices prepared at the other annealing temperatures. Furthermore, this pH-sensing device fabrication process is fully compatible with CMOS fabrication process technology. © 2012 Elsevier B.V. All rights reserved.
Citation
Applied Surface Science, 267, 206-211, 2013