Circular Interpolation using Siemens S7-1200

Simple item page
dc.contributor.authorCheypoca, Thepjit
dc.contributor.authorLuanpol, Amata
dc.contributor.authorWuti, Virot
dc.date.accessioned2026-08-06T10:39:45Z
dc.date.available2026-08-06T10:39:45Z
dc.date.issued2023-01-01
dc.description.abstractThis article proposes a way to control the movement of the step motor drive to control the movement of the 3 axes using a programmable logic controller (PLC) working instead of a numerical controller (NC). The workpiece can be milled the way it is needed, but the ability to control peripherals is limited, as it is a specific control system used to move the desired position. But the limitation of smaller PLC is that there is no order used to move directly as a curve, so a higher level of PLC is required, so smaller PLC are used to program curves with circular interpolation methods [1] to enable the use of curved motion.
dc.identifier.citation2023 9th International Conference on Engineering Applied Sciences and Technology Iceast 2023 Proceeding, 1-4, 2023
dc.identifier.doi10.1109/ICEAST58324.2023.10157875
dc.identifier.other2-s2.0-85165659837
dc.identifier.urihttps://dspace.kmitl.ac.th/handle/123456789/13958
dc.source2023 9th International Conference on Engineering Applied Sciences and Technology Iceast 2023 Proceeding
dc.subjectmotion control
dc.subjectPLC
dc.subjectProgrammable Logic Controller
dc.subjectS7-1200
dc.titleCircular Interpolation using Siemens S7-1200
dc.typeConference Paper

Files

Collections

Research