Nunak, Navaphattra
Loading...
Preferred name
Nunak, Navaphattra
Alternative Name
Nunak, N.
Nunak, Navapattra
Main Affiliation
Email
navaphattra.nu@kmitl.ac.th
2 results
Now showing 1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Estimating the Power Losses in Induction Motor using Temperature Monitoring(2025-01-01); ; The paper proposes the estimation of power losses in electrical machines using a measurement technique based on the temperature of the electrical machine and the heat transfer equation. To demonstrate this concept, the heat diffusivity of the induction motor can be illustrated through thermal images. This research addresses the impact of supply voltage unbalance on power loss in induction motors. The system comprises A contact temperature measuring circuit utilizing the IC LM 35DZ as a temperature sensor and signal converter, paired with a computer equipped with a National Instruments PCI 6014 data acquisition card. The experiment was conducted by adjusting the phase unbalance to 10%, 20%, and 50% to observe temperature changes. This allows for a direct temperature in the induction motor. The primary advantage of this method is that the machines do not need to stop or be removed from their operational process to measure their losses during preliminary maintenance. - Some of the metrics are blocked by yourconsent settings
Item type:Publication, An investigation of oil residue on surface by infrared thermography(2020-01-01); ; This work aims to propose a visual inspection, infrared thermography technique, of oil residual mass on stainless steel surface (SS) (hydrophilic surface representative) and polytetrafluoroethylene (PTFE) surface (hydrophobic surface representative). An improved understanding of the oil fouling characteristic is a key point to develop this technique. The effect of surface roughness on the oil contact angle, oil residual mass, and the resulting average temperature of the residues on SS and PTFE surface was studied. For the infrared thermography technique, the mass of oil adhered to each interface using heating at a temperature of 80<sup>0</sup>C for 10 minutes. SS AISI 304 plaques with the average surface roughness of 0.4, 0.8, and 3.2 µm and PTFE with that of 0.4 and 0.8 µm were examined. All samples were snapped top view using a thermal image camera. The average temperatures were obtained from the color spectrum of the thermal images. It could be summarized that the proposed measurement is possible to detect the accumulation of oil on the SS whereas it was not clearly different that on the PTFE surface. A greater oil residual mass on both hydrophilic and hydrophobic surfaces is a result of an increase in surface roughness and sequential wettability from the contact angle as expected. Moreover, each liquid-solid interfacial material has its specific surface characteristic. Finally, each liquid-solid interfacial material has its specific surface characteristic and the new and used oil-SS interface could be detected by infrared thermography technique.